Posted by Mike CA on September 07, 2009 at 23:18:43 from (99.28.152.102):
I have a '44 H I am wiring. This H didn't have lights, and the wiring I got it with was all "modern" (80's) aftermarket crap. So I'm rewiring it right.
It will have 3 lights, although the rear light is off a 300, and has a small black knob on it (Not original, but it's a gift). So, the question comes down to control. I was told that the 4-position would be correct, since a '44 has a cuttoff, not a VR. (not verified, just something I was told). But a 3-position would be more appropriate, since I don't need the 4th position. Unless someone knows of a neat use for the 4th position? (suggestions welcome)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
