Posted by Matt_in_Michigan on September 14, 2009 at 05:47:22 from (208.53.98.232):
Power steering and hydraulic problems have left me scratching my head and investigating. After installing the new-to-me hydraulic pump, I noticed underneath there were a couple big(3/16" -1/2") holes with nothing in them.
The one that struck me as most odd was on the cover plate for what CIH calls the PTO drive compartment(#18). According to the parts diagram, there's suppose to be a 3/8 MIP plug in it. There wasn't. What I found was no gasket, a nice view of the clutch, 50 years of grease caked inside that cover plate, and a broken grease fitting on a approx. 2" long nipple. Hope the picture helps explain what I'm looking at.
1. What the hell does this grease fitting go to? 2. Why is there grease around the clutch?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
