Posted by couv on September 15, 2009 at 19:21:51 from (24.32.176.78):
OK Experts : I'm finally wrapping up my 100.
The hydraulic lines from the pump to the Touch Control block :
My parts book doesn't list the bolts mounting the front flange to the hydraulic pump. They appear to need to be about 3/8 " Fine Thread X 2 1/2 " long, with a standard lock washer and nut. (2) required.
The book does list the bolts to mount the Touch Control end as "Part Number" bolts (#353331R1),and show them with some kind of washer, BUT DOES NOT describe them as 3/8 " Course Thread X 1 1/4 ". WHY aren't they a measurement bolt --- what is special about them? Can I use (3) "measurement bolts" ? What is special about the (3) wahsers ?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
