Posted by Wardner on September 24, 2009 at 17:22:50 from (4.154.247.63):
My hedge is 7' high and 7' wide. I had this IH balanced head mower on my 4000# forklift. Because it rained every other day in June and July, I wasn't able to use it. Plus I couldn't see the top of the hedge. Now I can if I flip the seat and stand up for good visibility.
The sickle bar will cut vertical and horizontal. It is rotated into position with electric/hydraulic power pack controlled from the operator's position.
The Borg-Warner clutch pump runs the knife. I can turn it on and off from a switch near the left headlight. I also have a switch for the lift.
I can even mow at night. It runs off the Electrall. I have been thinking about getting an antenna rotater.
I now have 15 V-belts installed on the tractor.
Somebody stop me before I mount the air end, oil cooler, and oil separator from my first air compressor. It's a Sullair 150 CFM. Takes about 45 hp. It's that or a welder (or maybe both).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
