Posted by Rudi on October 02, 2009 at 15:06:30 from (99.252.48.17):
In Reply to: cub timeing posted by Jonmac41788 on September 29, 2009 at 16:16:29:
There is a reason why IH provided the Blue Ribbon Service Manuals. So that techs could diagnose a problem and correct it the right way and without by guess and by golly. Lucky for Cub owners, we have virtual access to those tools. :D So print out the sections that are pertinent and take them with you to the Cub, it will be far easier to conduct the diagnostics.
Once you have eliminated the Timing Gears/Governor as the source of the fault, then I would suggest you read the GSS-1012 - Electrical Equipment Service Manual. Pay attention to what is discussed in Ignition System - Magneto - Pages 3 to 7. Get everything up to snuff according to this section and you should be good to go.
Very little can go wrong with mags.. generally although I have had a couple of bad ones the last little while. A bad mag is an unlikely culprit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
