Posted by John T on October 09, 2009 at 15:45:59 from (66.244.97.31):
In Reply to: 6V generator posted by heneryv1111 on October 09, 2009 at 14:26:16:
Glad you found the problem. The Motor Test tells a bunch...The belt tension and load are on the pulley end so they use a bearing out there. However a good lubed bushing still gives years of service on the brush end. I was thinking some DO NOT have a removeable plate and you have to use a bushing puller so if yours has the removeable plate its a piece of cake with bushing drivers and/or sockets like Jim was talking about.......Id have the commutator turned down smooth n shiny and segments undercut and install new brushes while in there and clean it all up nice n she ought to charge to beat the band. if not Bob or Jim will fix it for ya !!!!! Im too busy lol
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
