Posted by Mike CA on November 11, 2009 at 09:01:01 from (99.28.152.102):
I just need to verify what I think I know...
A person cannot adjust an H govenor while the tractor is running, correct? I think you cannot because there is oil that does into it, but since I don't see anything in writing, I just want to verify.
That being said, I guess the only thing I'm adjusting is the maximum movement, and the stop bolt, right? The reason I'm going to adjust it when it's done is because when I pull the throttle back to full, I get a lot of resistance and pull back. The tractor won't stay at full throttle because there is so much tension.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.