Posted by Wardner on November 15, 2009 at 18:45:11 from (4.154.242.192):
In Reply to: Re: H/I4 water pump posted by Jason the Red on November 15, 2009 at 16:13:17:
Good answer Jason. I could use you as a sidekick.
A couple of weeks ago, I went to a hydraulic shop that I rarely go to. Outside, the owner and his son were cutting up pallets. I had my IH parts book in hand and opened to the hydraulic cylinder page. The son and I assumed our respective sides of the counter.
I needed half a dozen O-rings. IH had kindly given the dimensions of each O-ring I needed and I had put a check mark on each item.
The kid scanned the page for about 10 seconds and said "You will have to leave the book and come back later. I can't do this right now".
I told him I was not coming back later because I was never coming back. As I left to get in my truck, I told the father/owner what had just happened. He got pissed and said if I didn't like the service I should buy the business. Damn, I wished I had had a snappy answer. Oh, well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
