Posted by Mark Peters on November 19, 2009 at 13:10:06 from (66.222.7.225):
Hey guys, I want to replace my hydraulic pump on my 300U with a new one I just bought. I have an I & T manual ,but that section just doesn`t seem complete to me.I don`t have the old pump off the 300 yet. Just wondering ,is there any tips or words of wisdom in doing this project? The one thing it don`t mention in the I&T manual is if there is a timing notch of some sort to line up the teeth from the pump gear to the cam gear. The manual says to turn engine over till #1 cyl. is on compression stroke and line up notch in crankshaft pulley with pointer on front cover, then remove distributor and then pump. Then for reassembly , it just says do the steps in reverse order.But ,like I said , no mention of lining up specific punched teeth to a specific punched notch. Seems to me it has to have that for proper timing?? I`m grateful for any and all advice. Thanks,Mark
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
