Posted by Mark on December 14, 2009 at 11:12:23 from (67.140.133.18):
Had a leak coming from the oil pan and/or rear main seal on a SC I recently bought. I dropped the pan and cleaned it up nice and tidy...didn"t find anything out of the ordinary. I looked up into the engine innards and that engine looks as if it were hot tanked yesterday...remarkably clean. I looked the rear main seal housing over and it all looked fine and I noticed somebody had used some blue silicone when they installed it. Somebody has been inside this engine or at least replaced the rear seal in the recent past.
OK...all seems fine until I start putting the bolts back in. I never noticed anything wrong when I removed them......but the the middle one on the FRONT main seal housing is quite obviously stripped. GRRRRRR!
No, I don"t want to have to down the thing in order to replace that seal and housing.....nothing wrong with the seal anyway.
Is it possible to use a self tapping bolt/machine screw that is just the least bit larger around than the original and make a quick fix of this? Yes, I know sooner or later the aluminum seal housing will have to be replaced. I"d rather it be later than sooner. Yes, I also know those aluminum housings get screwed by overzealous morons that think a little tighter is better...who the moron was before me I don"t know, I"m just stuck with the mess. And no....I don"t want prove what a moron I am by making things worse.....but I think a self tapping bolt/machine screw in the soft aluminum housing is feasible....but I want your opinions.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
