Posted by hoof print on December 16, 2009 at 19:26:26 from (208.44.160.51):
Say Glenn, I noticed you installed your original drawbar with your Saginaw 3pt.
I have a saginaw 3pt on an H and have considered installing the draw bar. I knew that it was possible to do so, but I always worried that I may not get full downward motion from the 3pt lift arms. Ever had any problems with your lift arms hitting the draw bar, or needed them to go lower than they are allowed to with it?
By the way, that is some neat M you have, I would love to have power steering and a welder on my old workhorse H.
I do have an original IH 2 way hydraulic valve, the saginaw 3pt I mentioned. Mine sure is a hand tractor.
I was looking through your photo bucket for more pictures of your m and saw what appeared to be an AMC Javelin! Am I correct on that? I have always wanted an AMX myself...love the old AMC's.
This post was edited by hoof print at 19:34:13 12/16/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.