Posted by Brian Luton on December 22, 2009 at 19:35:31 from (24.58.74.33):
Just a quick update. I've really appreciated everyones thoughts and ideas.
I got the tractor to fire today. Actually got more fire than I bargained for but it is a step in the right direction.
After going down the punch list on the electrical and fuel system and checking for compression which all seemed decent I tried putting a shot of fuel into each cylinder head. The tractor fired a few times. And died. I hit it with ether right away and full choked it for a few cranks, full opened it, and it fired and ran for about 15 seconds. I repeated the process and once it was running tried to coax it out of the garage. As I eased off the clutch it back fired out the air intake on the carb and this instantly ignited a paper towel I had catching dribble from a leaky fuel line fitting at the sediment bowl.(it was on the list for repair as soon as I could confirm the thing would fire again) Anyway it fired. And now it was on fire. The old lesson in always having a fire extinguisher handy paid off. A quick blast and it was out.
Anyway it seems I'd tried just about everything to start the tractor and wasn't getting even a pop. Perhaps something was just gummed up a bit and putting a bit of fuel in the cylinder heads directly gave me a couple hot and fast strokes which "re-awaked" things.
So that's where it stands. I need to fix the fuel line and hopefully it'll fire up again and I can work to dial things in.
Anyone have any fuel line thoughts? I've had problems getting steel brake lines and compression fittings to seal well. And heard mixed reviews of copper and rubber.
Thanks again everybody. And don't forget to always keep a fire extinguisher handy!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
