Posted by Kevin in MI on April 12, 2010 at 03:27:22 from (148.168.40.4):
Yesterday, I got around to replacing the seals behind the brake drums of my 43 H. When I took the cover off the right side, the drum flopped around like a fish out of water (discourged at this point, I didn't take the left cover off)! I though, this can't be good. So now I'm sure the bearing needs replacing. How difficult is it to remove the transmission cover? Is there anything I should pay special attention to? I figure I may as well do a thorough inspection, but would like to know what area(s) to look over extra carefully. Kevin
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.