Posted by mkirsch on April 27, 2010 at 05:07:54 from (64.80.108.57):
In Reply to: Rear Wheels posted by Kevin in MI on April 27, 2010 at 02:46:50:
Wheels dished in vs dished out was entirely dependent on the spacing of the rows that the farmer wanted to drive down.
Just judging by an unofficial, unscientific observation of tractors over the years, it seems that dished out is the most common. 40" rows were common back in the day, and the wider tractor was more stable.
There is a fleet of old letter series tractors in the area that are used to plow sidewalks in the winter. The wheels are dished in and shoved as far in as they go. I think the tires rub on the operator's butt as he goes down the road.
Wheel weights can be mounted on the inside or outside of the dish, it doesn't matter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
