Posted by MarkJ_in_IA on July 07, 2010 at 13:54:00 from (208.126.67.45):
After fighting with it for several years I finally got my McCormick 46 baler to tie some bales. On a few acres of ruined hay it baled at almost an 80% tie rate. Part of the problem may have been the hay had been on the ground 3 weeks and had 14 inches of rain dumped on it in that time. I took a lot of steps to get it that far from 0 to 80% and I'm confident it can be improved.
Things I've learned so far... When I got one side to tie decent I measured the stack of washers and made a pair of spacers out of pipe. (I'm tempted to make more and sell them on ebay.) It is easier to control the thickness by grinding pipe instead of jockying 10 washers. I also found that a consistant windrow with no wads or gaps improved the tying immensely. I found the best speed was 1/3 throttle in second gear (it was light hay) worked well for me.
There is hope for the old McCormick balers afterall,
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
