Posted by Chris Sw on September 23, 2010 at 15:33:33 from (174.54.5.1):
Over the past several weeks I have posted about charging problems with my H. Everyone's posts were very helpfull and I have grounded my feild terminal on the genny to a bolt that was out there close by. Re-polarized and ammeter went to high charging side. When lights come on the needle drops quite a bit but does not go to discharge. I placed my multimeter on the battery with lights off and tractor running and I am getting a reading of approx 13.8 volts. My question is that I'm only running a 6 volt system. Am I gonna fry my battery with this high voltage? Is it possible that when my genny was rebuilt it was mistaken for a 12 volt? When I turn my lights on with the tractor running I drop approx .2 volts. I've also had a problem with my antifreeze bubbling and coming outta the overflow tube, I'm talkin a steady stream comin out not just a few drips. I did not have a problem with this before I grounded the genny feild post, it may have nothing to do with the charging system but I figured I'de throw it out there. As always, any help is appreciated!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.