Posted by Zachary Hoyt on September 28, 2010 at 10:12:51 from (184.8.255.130):
In Reply to: Mag not firing posted by E.Frank H. on September 28, 2010 at 08:44:21:
I had to go through my H mag(which is the same mag as on the M) over the summer and I ended up putting in points, condenser, coil, point wire etc before I was through. It is doing well now, but it was a process. The folks on this board were very helpful, especially Janicholson. To get to your points remove the distributor cap and unscrew the three? screws you will find under there. Just keep taking it apart from there and you'll come to the points pretty soon. They're not hard to replace or to gap, especially if you had three arms. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.