Posted by E.Frank H. on September 28, 2010 at 08:44:21 from (205.188.116.73):
I have a farmall "M" that I use around my place and I never had any trouble geting it started. Sometimes it will sit for two months but usually always started. However, I recently tryed to start it and it hit a couple of times and then quit. I pulled the plugs and rotor cap and noticed that it wasn,t getting any fire. It has a magneto. Any suggestions will be appreciated. Could it be that the points in the mag are stuck shut, and if so, where are they located? My manuel dosen,t show a breakdown on magnetos.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.