Posted by chad from michigan on October 20, 2010 at 06:28:18 from (151.163.2.8):
Well I finaly have my IH-1000 loader frame home ready to install on my Farmall 100. It is missing the bucket and I have found a 4' bucket but have been considering making a 42" wide bucket instead. I am not sure what the cost will be but my thoughts were that it might be lighter and I would tend to not over load it since I am sure steering will be a problem. Any recomendations on bucket design or 4' vs 3'6" wide? Would 1/4" thick plate be good enough if I put a 3/8" thick cutting edge on it? Does anyone have deminsions of a loader bucket they could send me? It doesn"t have to be the IH bucket I can put the mounting brackets where I need them when I build it. Any thoughts on this would be great! Thanks Chad keep in mind the 4' bucket is like 6 hours away so just buying it isn't that easy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.