|
Farmall & IHC Tractors Discussion Board |
Re: Re: Reattatching Woods L59A Mower Deck to 130
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan 130 on July 13, 2000 at 19:33:35 from (24.4.252.144):
In Reply to: Re: Reattatching Woods L59A Mower Deck to 130 posted by Jerry Stevens on July 13, 2000 at 18:50:15:
Jerry, thanks for the followup. The pix would be much appreciated if it's not a lot of trouble. Can you tell me if the belt crosses from where it comes off the PTO pully before it goes through the idler pullys or does it just go straight to the nearest pully? If not, then I am afraid I have the wrong blades on mine although they are exactly liker the ones I pulled off. Also, I am not sure how to adjust tension on the belt other than using the different holes under the axle mount..usually one is too loose and the next is too tight.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
