Posted by Spectre168 on June 18, 2011 at 09:12:12 from (74.5.53.24):
I have a 656-D Hydro Utility.
The hydro seems to work okay whn not under load and when it is cold. Once it warms good and through, the drive seems to lose power to the point that the tractor will hardly move itself. The PTO will run and then drop out on level ground. The oil is fresh with a new filter. The oil level appears to be correct. My next move is to go through the linkage adjustments and try to get them back to specs. This is my first experience with a hydro, and I'm looking for ideas of where to proceed next. Any thoughts or suggestions would be appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
