Farmall & IHC Tractors Discussion Board |
Re: 1466 ELECTRICAL
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken D. on August 27, 2000 at 18:28:12 from (207.254.52.176):
In Reply to: 1466 ELECTRICAL posted by SCHILLO on August 27, 2000 at 14:26:38:
Hello, Schillo, Sounds like to me you got some wires crossed. Here's away to check them without a meter. Take a hot test wire off the battery plus side and touch each wire on the back of the switch. Watch which lights comes on and mark with a piece of masking tape where that wire goes too. Another words if you touch your test wire to a wire and it lights up the head lights then that wire would be labeled, headlites. If nothing happens when you touch your test lead to the wire, then that is the hot wire to the switch. Then look at the back of switch and it should have some lables in the moulded plastic as to what wire goes where. Sounds like you have the head lights on the dimmer side of the switch and the hot lead to the switch on the wrong terminal. You can figure the switch action out by running a hot lead to the terminal marked "B" as that would be the hot terminal for the switch. Then Use a 12V blub from a automotive lite as a check lite and besure to ground the case of the test lite and you orperate the switch to see what it does on the test lite and label each terminal. When them test lite dims that is the dash lite terminal. Keep going until all terminals are accounted for the number of wires your hooking up. Then it's just hooking up the tested wires to there proper place on the switch. Ken
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|