Posted by Tom Fleming on November 17, 2011 at 16:23:36 from (206.193.250.146):
In Reply to: Axle removal posted by freefour on November 17, 2011 at 05:45:27:
I too have redone all the seals on the final drives of an A. Same as the B or BN. And Gene has nailed it. Only difference is instead of a cherry picker, I used a chain hoist and trolley on an overhead I-beam with 4x4 cribbing under the rear end.
Used the hoist to pick up the rear of the tractor. built the cribbing and set tractor down on it. both wheels off the ground. used hoist to remove the final drive, and disassembled it while on the hoist. the hoist worked well as I had the rear axle aligned with the overhead I-beam. just rolled the trolley with the whole final drive away from the tractor. rolled it back when seals were done.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
