Posted by KrisM on December 09, 2011 at 16:55:40 from (74.209.50.29):
My farmall 340 was working fine one second, then the next the governor was hunting, and now it works when it wants. It will work for a second, then when under load it backs down to idle. If I give a pull on the carb linkage it will go back up to proper idle, then it will go back down. The spring is good as seen in oil fill hole and linkage outside the housing is all good and straight. Where to start now. How important is the adjustment of the bumper spring under the housing. All ideas are welcome so I don"t have to tear the old girl apart.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
