Posted by Rick Remmert on January 15, 2012 at 19:50:26 from (68.103.4.114):
Just spent the last 2 days getting ready to do an in the frame overhaul. Everything seems to be in really good shape. Someone had been in it before. It is going to need push rods for sure as 4 of them are bent. The exhaust of #1 was bent enough that it was rubbing a hole in the side of it. I do not see them listed in any of the parts places for sale, so I need to know where to get them. I did not know if you can tell from the picture if the head had ever been machine or if there some way to measure it. The machine marks look to be the ones from the factory. I would like to take about .050 or .060 off of it. The old sleeves and the pistons are the orginals. I will put the bigger sleeves with the domed pistons back in. I need to know the part number on the pushrods as the book lists a couple of different part numbers. The block has number 354893 R2 on it. The head has 251172 R. The intake valve has 57797-D TP and the exhaust valve has 57798-P with SIL-TXCR below it. Also, both the bleeder holes in the manifold are filled shut. I can not decide to unclog them or leave them. Any help on the pushrods would be appeciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
