|
Farmall & IHC Tractors Discussion Board |
Re: Re: copper fuel lines????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ray M41 on September 09, 2000 at 14:37:21 from (208.145.75.75):
In Reply to: Re: copper fuel lines???? posted by Andy Martin on September 09, 2000 at 13:47:08:
I guess I should have known about copper taking a set and getting stiff. I can remember when I was still an electrician we would renovate old buildings and the larger wiring would be real hard to pull out of the pipes. A few years ago I put a manual oil pressure gauge on my pickup and hooked it up with copper tubing. Made a couple of loops near the engine to absorbe the vibration. Guess I'll have to watch it now. Copper just made me feel more secure than that nylon tubing that comes with the gauge. It made a lot of noise for a while but now it is quite.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
