Farmall & IHC Tractors Discussion Board |
Re: 20's to 50's Factories
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Guy Fay on September 21, 2000 at 16:31:08 from (169.207.193.42):
In Reply to: 20's to 50's Factories posted by Chris Auer on September 21, 2000 at 10:00:55:
There's no doubt that hand skills have declined, but then how many of yesterday's workers had to deal with computers? You still get craftsmen and women today, with just as much determination and abilities as yesterday. And there are just as any layabouts and waste's of oxygen today as yesterday. However, it takes a lot more to build todays tractors- hydraulics done in clean rooms, computers done in clean rooms, not to mention tighter tolerences in engineering all over. I remember reading some tractor quality reports that the Fergusen Company had put together about the 2Ns they were buying from Ford Motor COmpany about 1945-46. They had found some press fits that were of by 1/16 of an inch! A large number of other problems were also noted. I haven't seen similar IH stuff, but I have read reports of worker behavior in Farmall Works from the 1940s and 1950s that were little different from the stories my sister told in the 1990s. One time, they shut down the entire engine assembly line because of a fight between two workers because one wanted a window open, while the other guy wanted it closed. Started a riot. Again, this is stuff I have read in the original documentation. No, I wasn't there. Yes, I'm prejudiced because I'm a member of the younger generation. But remember, the older generation has been calling the younger generation a bunch of bums for about 8,000 years now. It is the job of historians to expose these little repititions of history in the hopes that people can figure it out.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|