Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: H Water Pump
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red. Hmmmmmmm on September 22, 2000 at 13:50:50 from (12.75.198.56):
In Reply to: Re: Re: Re: Re: Re: H Water Pump posted by Tom A. on September 22, 2000 at 12:56:23:
Tom there should be 4 slots, every 90 degrees, and yes that is where you lock down the adjustable portion of the pulley for the main belt. I am wondering if by chance you have an aftermarket pump?? I know there were aftermarket parts for some of the IH parts but I really don't know about the water pump components. Place the fixed flange in a vice and see if you can pound the hub off. According to the parts picture, the pin hole should be in line with the grease fitting hole located on the end of the hub.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|