Farmall & IHC Tractors Discussion Board |
Re: 1958 IH350U Hydraulic System need help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big fred on October 05, 2000 at 17:05:19 from (208.51.245.145):
In Reply to: 1958 IH350U Hydraulic System need help posted by mark on October 05, 2000 at 14:24:55:
Mark, the regulator valve seat is indeed threaded. To get mine out I took an extra 13/16 socket and ground it so it had little nubs on it, about 1/16 high by a little less than 1/16 wide, and used that as a tool to remove the seat. Good idea to wrap that socket with a couple layers of masking tape or similar so you don't scratch the bore. After that it came apart pretty easy. Only thing I couldn't get out was the auxiliary safety valve (only on power steering equipped) that is on the other end of the valve block. If you don't have an exploded view to go by, go to your Case/IH parts guy and ask if he will print you a copy of that page, (Page 310 or 312 in the parts manual) It will be a great help. I found quite a bit of debris when I took out the safety valve orifice, but it wasn't on the screen, but in the hole. Be sure to blow out all passages thoroughly. My 300U is equipped with a couple remotes, it has two more control valves mounted ahead of the fast-hitch valve (near the front of the right side of the reservoir). Those remotes are for a loader, in my case, which is not currently mounted.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|