Posted by DaveLamp on August 22, 2012 at 08:57:40 from (69.54.29.239):
I have a 6", rear mounted, pitman arm sickle bar mower for my Super A. On the outside end of the cutter bar is a spring loaded rod bent around to make two rods that "rakes" the hay back towards the tractor so the end of the cutter bar closest to the tractor doesn"t clog up on the next pass. Someone needed it more than I did as it "disappeared" one night. The rod, the bracket, the spring and the bolt are all gone. I"ve looked through the archives on this site and I think it is a model 16A. I read that this is the only rear mounted mower that IH made for the super A. Is that correct? The only numbers I could find are on the "bar foot" (or whatever it"s called) closest to the tractor. They are 51491 R4. Obviously I need to replace these parts but I can"t find anywhere to get them. The IH dealer site doesn"t list any implement parts, at least as far as I could find. Did I not look close enough, or do I have to call them? If not at the IH site then where might I find these parts? TIA Dave L
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
