Posted by DirtyJ on December 17, 2012 at 13:59:59 from (68.169.155.140):
Hello All,
I am looking at a '49 SA for cultivating a 5 acre vegetable garden. I looked at one that seemed to be in pretty good repair with a few exceptions. I will preface my questions by saying that I am a decent mechanic, but don't have much money for parts.
The good:
The tractor started on the first bump when cold. It had not been run in a few weeks.
It shifted well through all gears and didn't hesitate in any of them.
The body seems to be in good condition with very little rust.
The hydraulics were fully functional, moving free and smooth.
The bad:
The steering was VERY loose. To use it for cultivating, I need substantially tighter steering. Is this something that I can adjust out? I saw what appeared to be an adjusting bolt with a lock nut on it. I was able to loosen the lock nut, but not the stud that it was locking.
The rear end sounded louder than I expected, particularly at the rear left wheel. Is this normal? To be clear, I am used to driving a '98 kubota that is relatively quiet. I may just be used to that. It sounded like a normal sound, just amplified (whine, not a grind).
It leaks a little of everything. The seller told me the last time that he filled anything up, which has been a while, and none of the levels were low. That being said, everything was a little wet with some fluid or another. Should I just expect this? I am used to dealing with dry equipment.
Any feedback is greatly appreciated. Thanks in advance!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
