Posted by WI Dave on March 29, 2013 at 09:47:46 from (71.82.169.44):
I had pics of how my H was wired before I tore it down for repairs, paint, etc. My hard-drive crashed and I lost the pics, though. All I can find is that there was a wire from the BAT terminal on the alt. to the - post on the ammeter, and all the other wires connected to the ammeter were on the + post. Is that even right? The alt was tested, and works fine. The tractor always started easily and ran fine with it"s old battery. Any tips for the proper way to wire this old alt are appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.