Posted by Roger Tomfohrde on April 19, 2013 at 08:25:52 from (204.77.50.87):
O.K. Anybody ever have the sway bar linkage get rusted solid on a fast hitch? I have soaked this thing for weeks now with various penetrants and am getting ready to take it to a shop to try and press it loose. It seems to let a little through but when I pound on it or pry when it is in a big vise all I do is move the bench. I tried to move it with it on the tractor but it bends the two plates but does not pivot. I hope I don't have to replace it because I may have to sell it because of moving. This is the shaft and tube arrangement under the middle that keeps the draw bar from moving side to side. What should I try next? I thought about heating but my torch set is too small to do a good job. I ended up taking the whole thing back off the 560 because I didn't want to bend it up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.