Posted by RED_Port on September 20, 2013 at 15:59:51 from (66.181.117.197):
I am a recent new owner of a lovely 1937 Farmall F-12 with a rusted, now leaking intake manifold. It was running perfectly until a thin rusted area let go and caused a large intake air leak. I have a new replacement manifold and the old one fully loosened, ready to be removed, but the vertical governor shaft is preventing sliding the old manifold horizontally enough to clear its' mounting studs. I don't readily see how it is removed. I have removed the surrounding tower assembly and upper linkage. There is a locknut with cotter pin at the shaft's base I have removed... does the upper shaft unscrew from the lower portion at the bearing, or below it perhaps, within the housing? I don't want to force anything until I know the proper dis-assembly steps. Any guidance would greatly be appreciated... Thank you!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
