|
Farmall & IHC Tractors Discussion Board |
Re: Farmall C governor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big fred on December 04, 2000 at 13:02:12 from (12.13.226.12):
In Reply to: Farmall C governor posted by Chris Bean on December 04, 2000 at 11:07:51:
You unhook the rod to the carb and the rod to the operator's speed selector lever, undo the 8 or so bolts holding it on and pull straight forward. On the B it can be removed without removing the fan or radiator, not sure on the C. While you have it off, check it out thoroughly, I found a bent shaft in mine, fifty bucks, but it also had an accumulation of rust, ended up replacing some bearings and springs. Parts should be available at your Case/IH dealer.
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
