|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Re: IH2400 (IH454) metal in hydraulic oil HELP!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kirk on December 20, 2000 at 17:15:40 from (216.192.177.43):
In Reply to: Re: Re: Re: Re: Re: Re: IH2400 (IH454) metal in hydraulic oil HELP! posted by ltf in nc on December 20, 2000 at 15:42:15:
That's a good point you would think the metal would sink to the bottom. But, the metal trash is always on the intake side of the filter. I wonder if the pressure relief for the pump is located near the fluid intake for the filter. Hope to find out soon, I've ordered the manuals and when I get them I'll be looking for the fluid flow diagram. Thanks for the ideas.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
