|
Farmall & IHC Tractors Discussion Board |
Re: Missing Serial Number - Farmall 130
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Glen 130 on December 20, 2000 at 19:11:44 from (209.90.133.186):
In Reply to: Missing Serial Number - Farmall 130 posted by Glen 130 on December 20, 2000 at 17:31:06:
Thanks Dan 130 and Bus Driver.
I'm still at a bit of a loss! I don't see anything at all. I was thinking that if it was paint covered I would see the outline and if it was missing I would see the holes for the securing rivots. If it was an aluminum plate say 2.5" by 1.5" I thought that I would at least see the attaching holes for the rivots or screws at where the corners had been. Can either of you tell me how big the plate is and how it was fastened? Thanks Again, Glen
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
