Posted by crlndy on July 13, 2014 at 08:27:22 from (99.241.193.78):
I recently acquired a belly mount sickle mower that is not quite complete. I hope someone can answer some questions for me. Photos are attached to help.
I believe this is a #22 but how do I know if it is for a Cub or a Super A? Or does it matter? I am hoping to mount it on a Super A.
If it fits on to a Super A, what diameter should the drive pulley that mounts on the tractor PTO shaft be? I have heard 7" but would appreciate confirmation. I have seen other postings noting a company called Browning that makes pulley sheaves. Can someone give me contact info or a website for Browning?
What size of belt? Length and width?
What length is the pitman arm? My Case IH dealer says 33" but my measurements suggest 30 1/2". The old pitman arm is gone. Which is correct?
Finally, I have seen in a parts manual a "Rockshaft Extension" that attaches to the lift chain on the mower and then presumably to the rockshaft arm on the touch control hydraulics. How essential is this? Any idea where to get it?
My local Case IH dealer basically says all of these parts are discontinued.
This post was edited by crlndy at 08:37:09 07/13/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
