|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Stuck MD
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon on January 02, 2001 at 15:51:40 from (209.172.217.180):
In Reply to: Re: Re: Re: Re: Stuck MD posted by Poor Farm Jim on January 02, 2001 at 08:25:43:
Where you located at? I'm here in N.E Ks. I'm going through the same deal you are, only with a 450D. I have already put over $100 in the injection pump, and that was replacing 1 seal. I was quoted $500 just fer new seals and gaskets for the pump, and over $750 for a complete rebuild. I have heard that its $400 a hole for a rebuild, then new main bearings are $100 a piece, and there is a couple including the camshaft bearings that are hard to find. Feel free to email me to talk more about them.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
