|
Farmall & IHC Tractors Discussion Board |
Re: Tight lift-all pump?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Theman on January 26, 2001 at 11:27:35 from (204.149.23.2):
In Reply to: Tight lift-all pump? posted by Bergen on January 26, 2001 at 05:35:46:
Since the pump shaft turns right up to final torque, I would not suspect the gears. There may be an end-play issue that hasn't been addressed yet. Is the new gasket the same thickness as the old one? Perhaps the cover you are tightening down is moving in too close. In some cases, (may not apply here) shimming with gaskets of varying thicknesses have been used by many manufacturers to control clearances. I found this out the hard way on a mower gearbox. Had way too much slop until I started peeling layers off of the gasket until backlash was perfect. An old mechanic friend told me about this. It turned out to be four separate gaskets.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
