Antique Tractor Paint and Bodywork |
Re: Question about Orange Peel
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod (NH) on July 25, 2005 at 19:42:55 from (64.140.200.138):
In Reply to: Re: Question about Orange Peel posted by Charles Park on July 25, 2005 at 11:11:22:
Well, it's my opinion. Others will disagree. I just think that there are too many that are understandably eager for that perfect job with only a little practice in application. They wind up neglecting their technique in favor of after-the-fact corrective work that might not have been necessary otherwise. Hoods and fenders are probably the easiest tractor parts to compound but again, it depends on the actual configuration. Many tractor parts, even some sheet metal areas, do not lend themselves as easily to power compounding as an automobile hood or door panel where the contours are broader and usually more regular. Leaving some excessive peel areas intact because of an inability to effectively get at and compound them is poor, I think. I suppose working through extremely fine (say 2000) grits by hand and compounding by hand in such areas is a possibility but would not be something I would look forward too. There are better ways to spend your time :o). Take a look at the basic causes for orange peel to see if you can try to eliminate most of it and avoid the final sanding/compounding bit altogether. In the end only you can decide how much peel, if any, is acceptable. During painting one of my AC-B fenders recently I got a little peel in the final clearcoat after essentially a near perfect application of the color. It happens - but it was my own fault - I think I was holding the gun a little too far away to avoid runs at the last step. Too cautious of me. Anyway, it was not serious enough to do anything about. I could have sanded and compounded but I didn't want to bother. I could also have sanded and reshot a couple of coats of clear but didn't want to bother doing that either. Of course this work is for myself and I am not in it to please anyone else or to enter show contests. It only matters that I am reasonably pleased with my own product - and only I can decide that.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|