Posted by bc on June 01, 2011 at 09:44:08 from (71.158.215.152):
Hi. I have a 25 gal. Fimco sprayer with a 12v 2.1 gpm flojet pump that quit working last night. I filled it with water this weekend and sprayed for a while and it worked fine. Then I added some roundup last night. It sprayed for a few minutes with the hand wand just fine. Had the return valve adjusted so it would put out about 50 psi when the hand wand wasn't being used.
Then nothing came out. If I closed the hand wand and let it build pressure for a couple seconds then it had enough pressure to spray for a couple seconds before dwindling down to nothing. I sprayed for a few minutes by opening and closing the hand wand until the pump motor just quit all together.
I have 12 volts going into pump motor with the switch off but when I turn on/flip the switch on the end of the pump, then the voltage reading goes to 0. The motor doesn't spin and it wasn't hot. With pump motor unpluged I get a 0 reading for resistance with the switch off but when I switch it on, I have continuity. The fuse on the end of the pump motor is not blown.
I figure the motor is either locked up or a winding went bad. This evening I will try blowing some air through it and take it apart.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.