Posted by Tx Jim on June 27, 2011 at 03:05:40 from (67.142.163.28):
In Reply to: no baler slip clutch posted by snoop-nc on June 26, 2011 at 18:58:05:
I was taught that the slip clutch should slip a little on every plungerhead stroke under load.
My only real experience is with JD sq balers. All of them since the 214 & 14T models have slip clutches to protect the baler pto shafts. When flywheel shear bolt breaks if powered by a large enough tractor one can keep baling if slip clutch is TOO tight or frozen/rusted. On the other hand if plungerhead stop causes shear pin to break then slip clutch must slip or baler pto shaft will be twisted.
This post was edited by Tx Jim at 03:08:20 06/27/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
