Posted by James Herrman on September 29, 2011 at 17:59:52 from (66.249.53.229):
Well boys, need some advice. Have been on the Allis board, but I might have not asked the question right. Here's what I would like to attempt and don't know how to do it. I have a G230 Allis engine out of a combine and also have a Farmall F20 with no engine. Is it possible to put the engine into the F20??? I saved the engine from the scrappers and also the F20. How do I go about finding a clutch assembly to put on the engine. All it has is a shaft coming out the back. Someone said that a WD45Diesel might bolt up, but all I want is a clutch assembly and bell housing to bolt up to the F20 trans. Am not cutting anything up that is original, just trying to make something out of what I have. ANY ideas would be welcome. Thanks guys. Seems like this forum covers just about anything, not just one brank. Am in ILL.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
