Nope he is not as i have seen it happen and it will eat a valve so fast your head will spin . Just got done doing a valve job on one of my 706 gassers BECAUSE OF a burnt valve and went and hooked up to the New Holland grinder mixer to grind a batch of hog feed . Pulled the big screen out and put the small hole screen in and went to grinding . I just looked to see how much corn was in the tank and all of a sudden she sputtered and puked a red hot chunk out the stack and started to die and was missing AGAIN . Took the 708 off the grinder and finished with the S/MTA . Pulled the head and the brand new exhaust valve had the nicest VEE torched in it and a second one was almost thru , I had just put all new valves in that head. This is when i learned about the low ash oil . And yes it cost more but i do not get my rocks off doing valve jobs even though i can do them myself. Does it work you can bet the farm on that as since we have switched to the low ash we have never ate another exhaust valve.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
