Mike, its really none of my business per say, but you are posting and asking for advice. By code, you are allowed to work up to the main on the house side. From the main to the meter is a licensed electrician, by code.
My concern is that 100 amps will smoke you in a heart beat. On the other side of that meter to the pole (transformer) is considerably more than that. I understand that you are trying to make repairs, but some of the questions that I saw you ask this time and the last go round, you really should get an electrician involved.
I had a buddy that sided houses for a living. He purchased a house that he and his fiance' were going to live in after their upcoming marriage. The house needed some work and he had friends from different trades helping him out, as friends do for friends. Thing is, he was the siding guy, so that he was doing on his own when he had time. Aluminum scafolding and a screw gun one dewy morning, and he bent over then stood up and touched his head to the service from the pole to the meter. The little neighbor girl from next door let their dog out and happened to go out with the dog and saw him lying dead on the ground with his boots smoldering. He had purchased a golden retriever from some neighbor a mile or so away, that after his death got the dog back, as a young adult. Those people let it out in a fenced yard and it escaped a few times, finding its way back to my dead buddy's house, his then dead owner, and thats where the new owners would find it, sitting outside waiting for its master, my buddy to come let it in, but he never did. It was sad to witness, all of it. From the main to the pole is considerably more than 100 or 200 amp. I could be wrong, but I think the circuit breaker on the transformer is like 7.5K.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
