Well if you a talking bout Me Lsd, yes I have work on pumps, tanks, Own My own drilling rig till last fall. have also worked on oil wells and done My share of fishing, too bad you can't read. never said he couldn't pull it, said for him NOT to pull it! said he would have his's hands full. Don't know how old the man might be, never know what you might run into pulling a pump, ever pulled one that the cable guard has come half way off? acts just like a great big fish hook. ever pulled one with cheap plastic fittings on it that are half broke off? ever pulled one that had so much iron built up on the inside of a 4" liner that ya had to keep pulling up and pushing down while ya worked it round in a circle to get the damn thing out? Think it's worth telling someone I have never met to go ahead grab a hold of that there Damn pump and yank it out of that 15,000 dollar well, ell you don't need some 1,000 dollar pump guy! Glad you didn't work for Me on weekends or any other time for that matter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
