Posted by Doug - Iowa on July 25, 2012 at 06:31:02 from (97.64.139.194):
I usually keep my brakes working without too much trouble but I've got one trailer that is getting the best of me. Maybe one of you all can see what I'm missing. Here's what I've done so far:
Hitched truck to a buddy's trailer, I can lock them up both on the pedal and on the manual over-ride, so I'm assuming its not the truck.
Hitched to the problem trailer, I have all lights working so I'm assuming I have a good ground.
I can hear clicking from the brakes but have no braking effort.
I have 11 volts at the connector on the truck, and at the first junction box on the trailer on the brake circuit. It varies down to 5 volts as you turn down the controller as expected. This is with the engine off so probably another volt or two when running.
I removed both wheels on one side and inspected the innards. Magnets show some wear but not worn down to the cores (the trailer is older but only has I'd guess 10,000 miles on it). Pads are good, no uneven wear. I did set them up a little with the adjuster, but still no work.
I followed the wiring along the frame and between the axles, no indication of corrosion or bad connections.
So, I plan to open up the other side tonight and see if one of the magnets is shorting and taking all the current. I also thought about running a hot wire directly to the junction box from the truck and see if I can bypass the controller and trailer wiring to that point. I've had magnets fail before but not all four at the same time, so I can't help but think it is a wiring issue. Any ideas?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.