Suggestion was made to put bales in rows. Here in SC if you put bales flat side to flat side they will develop rottern spots where they are touching, unless, of course, the bales are covered. this is due to moisture working it's way down between the bales. Bales stored outside will be all right here if the hay was baled with the proper moisture to begin with. This is old news, observed years ago after big round balers first came out.
Round bales that are tight and well wrapped will rot from the ground up, so the best way to preserve round bales outside is to store them off the ground, like on pallets. This is time consuming and expensive.
None of this should be taken to mean that rounds bales ourside will store indefinately. Eventually they will rot, depending on how wet the climate is.
The ag college experts who have experimented here say that net wrap bales will resist moisture better than twine wrapped, unless the twine is wrapped close, like maybe 2-6 inches apart or maybe 4-6 inches apart.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
