Posted by tedregentin on August 01, 2012 at 21:42:15 from (216.110.201.79):
In Reply to: Shop owners ? posted by Bryan iniowa on August 01, 2012 at 18:48:22:
My partner and I own a six hoist, ten bay shop. We have just three employees. We have a stack of job applications that is inches thick. It's funny, but not one of them would we hire, even though we have enough work to add one or two techs. The three that we have are top techs, and we pay them well. We also try to keep a pleasant and low stress work place. All three were hired strictly by word of mouth. They had been through the dealership ratrace, or had worked for shops with ethics problems. We have put the word out that we are looking for a Wyo-tech grad who has some skills. You might try getting in touch with one of the better tech schools if you have time and patience to train someone. Hope this helps, Ted
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
